Tektronix 1760 Bedienungsanleitung PDF herunterladen (Seite 151)

Appendix B: Remote Connectors

1760 Series Component Waveform/Vector Monitor User Manual

B-5

RS232 Connector

The serial interface has a driver built in for RS232 serial

binary data i nterchange. The operational m ode is full du-

plex. T he da ta rate is selectable through the Configure menu

for either 1200, 4800, or 9600 baud; data type is asynchro-

nous. Figure B-3 shows the pin assignments.

DATA

CONNECTION

NUMBER

1. DCD

2. RXD (RECEIVED DATA)

3. TXD (TRANSMITTED DATA)

4. DTR (DTE READY)

5. SIGNAL GROUND

6. DCR (DCE READY)

7. RTS (REQUEST TO SEND)

8. CTS (CLEARTOSEND)

9. NOT CONNECTED

RS232

Figure B-3. Rear panel RS232 connector.

NOTE

The function of the RS232 connector may not be

supported at the time of this printing. The RS232

interface is used during an upgrade of the instru-

ment software. Contact Tektronix for information

on availability of software upgrades and RS232

remote control commands.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 179 180

Keine Kommentare

Tektronix 1760 Bedienungsanleitung Seite 151